Regulation No 87 of the Economic Commission for Europe of the United Nations ... (42010X0630(03))
INHALT
Regulation No 87 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of daytime running lamps for power-driven vehicles
- Regulation No 87 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of daytime running lamps for power-driven vehicles
- 1. SCOPE
- 2. DEFINITIONS
- 3. APPLICATION FOR APPROVAL
- 4. MARKINGS
- 5. APPROVAL
- 5.1. General
- 5.2. Composition of the approval mark
- 5.3. Arrangement of the approval mark
- 5.3.1. Independent lamps
- 5.3.2. Grouped, combined or reciprocally incorporated lamps
- 5.3.3. Lamps reciprocally incorporated with other lamps, of which the lens may also be used for other types of devices
- 6. GENERAL SPECIFICATIONS
- 7. INTENSITY OF LIGHT
- 8. APPARENT SURFACE
- 9. COLOUR OF LIGHT
- 10. TEST PROCEDURE
- 11. HEAT RESISTANCE TEST
- 12. MODIFICATIONS OF A TYPE OF DAYTIME RUNNING LAMP AND EXTENSION OF APPROVAL
- 13. CONFORMITY OF PRODUCTION
- 14. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 15. PRODUCTION DEFINITELY DISCONTINUED
- 16. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS AND OF ADMINISTRATIVE DEPARTMENTS
- ANNEX 1
- COMMUNICATION
- (Maximum format: A4 (210 × 297 mm))
- ANNEX 2
- EXAMPLE OF ARRANGEMENT OF THE APPROVAL MARK
- Figure 1
- Examples of possible markings for grouped lamps situated at the front of the vehicle
- Figure 2
- Lamp reciprocally incorporated with a headlamp
- Figure 3
- ANNEX 3
- PHOTOMETRIC MEASUREMENTS
- 4. Photometric measurement of lamps
- 5. Table of standard light distribution
- Figure 4
- Light source modules
- ANNEX 4
- Minimum requirements for conformity of production control procedures
- 1. GENERAL
- 2. MINIMUM REQUIREMENTS FOR VERIFICATION OF CONFORMITY BY THE MANUFACTURER
- 2.1. Nature of tests
- 2.2. Methods used in tests
- 2.3. Nature of sampling
- 2.4. Measured and recorded photometric characteristics
- 2.5. Criteria governing acceptability
- ANNEX 5
- MINIMUM REQUIREMENTS FOR SAMPLING BY AN INSPECTOR
- 1. GENERAL
- 2. FIRST SAMPLING
- 2.1. The conformity is not contested
- 2.2. The conformity is contested
- 2.3. Approval withdrawn
- 3. REPEATED SAMPLING
- 3.1. The conformity is not contested
- 3.2. The conformity is contested
- 3.3. Approval withdrawn
- Figure 1
- ANNEX 6
- MINIMUM ANGLES REQUIRED FOR LIGHT DISTRIBUTION IN SPACE
Feedback