Regulation No 75 of the Economic Commission for Europe of the United Nations ... (42011X0330(02))
Regulation No 75 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of pneumatic tyres for motor cycles and mopeds
- Regulation No 75 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of pneumatic tyres for motor cycles and mopeds
- 1. SCOPE
- 2. DEFINITIONS
- 3. MARKINGS
- 4. APPLICATION FOR APPROVAL
- 5. APPROVAL
- 6. REQUIREMENTS
- 6.1. Dimensions of tyres
- 6.1.1. Section width of a tyre
- 6.1.2. Outer diameter of a tyre
- 6.1.3. Method of measuring pneumatic tyres
- 6.1.4. Tyre section-width specifications
- 6.1.5. Tyre outer-diameter specifications
- 6.2. Load/speed performance test
- 6.3. Dynamic growth of tyres
- 7. MODIFICATIONS OF THE TYPE OF PNEUMATIC TYRE AND EXTENSION OF APPROVAL
- 8. CONFORMITY OF PRODUCTION
- 9. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 10. PRODUCTION DEFINITELY DISCONTINUED
- 11. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR APPROVAL TESTS, AND OF ADMINISTRATIVE DEPARTMENTS
- Appendix
- EXPLANATORY FIGURE
- (See paragraph 2 of the Regulation)
- ANNEX 1
- COMMUNICATION
- (maximum format: A4 (210 x 297 mm))
- ANNEX 2
- ARRANGEMENT OF THE APPROVAL MARK
- ANNEX 3
- ARRANGEMENT OF TYRE MARKINGS
- ANNEX 4
- ANNEX 5
- ANNEX 6
- METHOD OF MEASURING PNEUMATIC TYRES
- ANNEX 7
- PROCEDURE FOR LOAD/SPEED PERFORMANCE TESTS
- 1. PREPARATION OF TYRE
- 2. TEST PROCEDURE
- 3. EQUIVALENT TESTS
- ANNEX 8
- TYRE LOAD CAPACITIES AT VARIOUS SPEEDS
- ANNEX 9
- TEST PROCEDURE FOR THE DYNAMIC GROWTH OF TYRES
- 1. SCOPE AND RANGE OF APPLICATION
- 2. DESCRIPTION OF TEST PROCEDURE
- 2.2. Contour outline device
- 3. EXECUTION OF TEST
- 4. EVALUATION
- Enveloping curve for centrifugal growth test
Feedback