Regulation No 7 of the Economic Commission for Europe of the United Nations (... (42010X0612(01))
INHALT
Regulation No 7 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of front and rear position lamps, stop-lamps and end-outline marker lamps for motor vehicles (except motor cycles) and their trailers
- Regulation No 7 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of front and rear position lamps, stop-lamps and end-outline marker lamps for motor vehicles (except motor cycles) and their trailers
- 0. SCOPE
- 1. DEFINITIONS
- 2. APPLICATION FOR APPROVAL
- 3. MARKINGS
- 4. APPROVAL
- 4.1. General
- 4.2. Composition of the approval mark
- 4.3. Arrangement of the approval mark
- 4.3.1. Independent lamps
- 4.3.2. Grouped, combined or reciprocally incorporated lamps
- 4.3.3. Lamps reciprocally incorporated with a type of headlamp of which the lens is also used for other types of headlamps
- 5. GENERAL SPECIFICATIONS
- 6. INTENSITY OF LIGHT EMITTED
- 7. TEST PROCEDURE
- 8. COLOUR OF LIGHT EMITTED
- 9. CONFORMITY OF PRODUCTION
- 10. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 11. PRODUCTION DEFINITELY DISCONTINUED
- 12. REMARKS CONCERNING COLOURS AND PARTICULAR DEVICES
- 13. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS, AND OF ADMINISTRATIVE DEPARTMENTS
- 14. TRANSITIONAL PROVISIONS
- ANNEX 1
- Front and rear position lamps, end-outline marker lamps and stop-lamps: minimum angles required for light distribution in space of these lamps
- (1)
- ANNEX 2
- COMMUNICATION
- (Maximum format: A4 (210 × 297 mm))
- ANNEX 3
- EXAMPLES OF ARRANGEMENTS OF THE APPROVAL MARKS
- 1.
- Front position (side) lamp
- 2.
- Rear position (side) lamp
- 3.
- Stop-lamp
- 4.
- Device comprising both a rear position (side) lamp and a stop-lamp
- 5.
- Marking of independent lamps
- 6.
- Simplified marking of grouped, combined or reciprocally incorporated lamps when two or more lamps are part of the same assembly
- 7.
- Lamp reciprocally incorporated with a headlamp
- 8.
- Light source modules
- ANNEX 4
- PHOTOMETRIC MEASUREMENTS
- 1. Measurement methods
- 2. Table of standard light distribution
- 3. Photometric measurement of lamps
- ANNEX 5
- COLOURS OF LIGHTS: CHROMATICITY COORDINATES
- ANNEX 6
- MINIMUM REQUIREMENTS FOR CONFORMITY OF PRODUCTION CONTROL PROCEDURES
- 1. GENERAL
- 2. MINIMUM REQUIREMENTS FOR VERIFICATION OF CONFORMITY BY THE MANUFACTURER
- 2.1. Nature of tests
- 2.2. Methods used in tests
- 2.3. Nature of sampling
- 2.4. Measured and recorded photometric characteristics
- 2.5. Criteria governing acceptability
- ANNEX 7
- MINIMUM REQUIREMENTS FOR SAMPLING BY AN INSPECTOR
- 1. GENERAL
- 2. FIRST SAMPLING
- 2.1. The conformity is not contested
- 2.2. The conformity is contested
- 2.3. Approval withdrawn
- 3. REPEATED SAMPLING
- 3.1. The conformity is not contested
- 3.2. The conformity is contested
- 3.3. Approval withdrawn
- Figure 1
Feedback