Commission Regulation (EU) 2019/2021 of 1 October 2019 laying down ecodesign requ... (32019R2021)
INHALT
Commission Regulation (EU) 2019/2021 of 1 October 2019 laying down ecodesign requirements for electronic displays pursuant to Directive 2009/125/EC of the European Parliament and of the Council, amending Commission Regulation (EC) No 1275/2008 and repealing Commission Regulation (EC) No 642/2009 (Text with EEA relevance.)
- COMMISSION REGULATION (EU) 2019/2021
- of 1 October 2019
- laying down ecodesign requirements for electronic displays pursuant to Directive 2009/125/EC of the European Parliament and of the Council, amending Commission Regulation (EC) No 1275/2008 and repealing Commission Regulation (EC) No 642/2009
- (Text with EEA relevance)
- Article 1
- Subject matter and scope
- Article 2
- Definitions
- Article 3
- Ecodesign requirements
- Article 4
- Conformity assessment
- Article 5
- Verification procedure for market surveillance purposes
- Article 6
- Circumvention and software updates
- Article 7
- Indicative benchmarks
- Article 8
- Review
- Article 9
- Amendment to Regulation (EC) No 1275/2008
- Article 10
- Repeal
- Article 11
- Entry into force and application
- ANNEX I
- Definitions applicable for the Annexes
- ANNEX II
- Ecodesign requirements
- A. ENERGY EFFICIENCY REQUIREMENTS
- 1.
- ENERGY EFFICIENCY INDEX LIMITS FOR ON-MODE
- B. ALLOWANCES AND ADJUSTMENTS FOR THE PURPOSE OF THE EEI CALCULATION AND FUNCTIONAL REQUIREMENTS
- 1.
- Electronic displays with automatic brightness control (ABC)
- 2.
- Forced menu and set up menus
- 3.
- Peak white luminance ratio
- C. OFF MODE, STANDBY AND NETWORKED STANDBY MODE REQUIREMENTS
- 1.
- Power demand limits other than on-mode
- 2.
- Availability of off, standby and networked standby modes
- 3.
- Automatic standby in televisions
- 4.
- Automatic standby in displays other than televisions
- D. MATERIAL EFFICIENCY REQUIREMENTS
- 1.
- Design for dismantling, recycling and recovery
- 2.
- Marking of plastic components
- 3.
- Cadmium logo
- 4.
- Halogenated flame retardants
- 5.
- Design for repair and reuse
- E. INFORMATION AVAILABILITY REQUIREMENTS
- 1.
- Availability of software and firmware updates
- ANNEX III
- Measurement methods and calculations
- 1.
- General conditions
- 2.
- Measurements of on mode power demand
- Measurements of peak white luminance
- ANNEX IV
- Verification procedure for market surveillance purposes
- 1.
- General procedure
- 1.1.
- Verification procedure for requirements established in Annex II, point B.1
- 1.2.
- Verification procedure for requirements established in Annex II, point B.2
- 1.3.
- Verification procedure for requirements established in Annex II, point B.3
- 1.4.
- Verification procedure for requirements established in Annex II, point C.1
- 1.5.
- Verification procedure for requirements established in Annex II, point C.2
- 1.6.
- Verification procedure for requirements established in Annex II, point C.3
- 1.7.
- Verification procedure for requirements established in Annex II, point C.4
- 1.8.
- Verification procedure for requirements established in Annex II, point D and E
- 2.
- Procedure if requirements are not achieved
- 3.
- Verification tolerances
- ANNEX V
- Benchmarks
Feedback