Regulation No 6 of the Economic Commission for Europe of the United Nations (... (42014X0718(01))
INHALT
Regulation No 6 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of direction indicators for power-driven vehicles and their trailers
- Regulation No 6 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of direction indicators for power-driven vehicles and their trailers
- 0. SCOPE
- 1. DEFINITIONS
- 2. APPLICATION FOR APPROVAL
- 3. MARKINGS
- 4. APPROVAL
- 4.1. General
- 4.2. Composition of the approval mark
- 4.3. Arrangement of the approval mark
- 4.3.1. Independent lamps
- 4.3.2. Grouped, combined or reciprocally incorporated lamps
- 4.3.3. Lamps reciprocally incorporated with other lamps, of which the lens may also be used for other types of headlamps.
- 5. GENERAL SPECIFICATIONS
- 6. INTENSITY OF LIGHT EMITTED
- 7. TEST PROCEDURE
- 8. COLOUR OF LIGHT EMITTED
- 9. MODIFICATIONS OF A TYPE OF DIRECTION INDICATOR FOR MOTOR VEHICLES AND THEIR TRAILERS AND EXTENSION OF APPROVAL
- 10. CONFORMITY OF PRODUCTION
- 11. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 12. PRODUCTION DEFINITELY DISCONTINUED
- 13. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS, AND OF TYPE APPROVAL AUTHORITIES
- 14. TRANSITIONAL PROVISIONS
- ANNEX 1
- Categories of direction indicators: Minimum angles required for light distribution in space of these categories of direction indicators
- (1)
- ANNEX 2
- COMMUNICATION
- (Maximum format: A4 (210 × 297 mm))
- ANNEX 3
- EXAMPLES OF ARRANGEMENTS OF THE APPROVAL MARKS
- Figure 1
- Figure 2
- Simplified marking of grouped, combined or reciprocally incorporated lamps when two or more lamps are part of the same assembly
- Model A
- Model B
- Model C
- Figure 3
- Lamp reciprocally incorporated with a headlamp
- Figure 4
- Marking of independent lamps
- Light source modules
- Marking of interdependent lamps
- ANNEX 4
- PHOTOMETRIC MEASUREMENTS
- 1. MEASUREMENT METHODS
- 2. TABLE OF STANDARD LIGHT DISTRIBUTION IN SPACE FOR DIRECTION INDICATOR LAMPS OF CATEGORIES 1, 1A, 1B, 2A, 2B.
- 3. PHOTOMETRIC MEASUREMENT OF LAMPS
- ANNEX 5
- MINIMUM REQUIREMENTS FOR CONFORMITY OF PRODUCTION CONTROL PROCEDURES
- 1. GENERAL
- 2. MINIMUM REQUIREMENTS FOR VERIFICATION OF CONFORMITY BY THE MANUFACTURER
- 2.1. Nature of tests
- 2.2. Methods used in tests
- 2.3. Nature of sampling
- 2.4. Measured and recorded photometric characteristics
- 2.5. Criteria governing acceptability
- ANNEX 6
- MINIMUM REQUIREMENTS FOR SAMPLING BY AN INSPECTOR
- 1. GENERAL
- 2. FIRST SAMPLING
- 2.1. The conformity is not contested
- 2.2. The conformity is contested
- 2.3. Approval withdrawn
- 3. REPEATED SAMPLING
- 3.1. The conformity is not contested
- 3.2. The conformity is contested
- 3.3. Approval withdrawn
- Figure 1
Feedback