COMMISSION REGULATION (EU) 2019/2022
of 1 October 2019
laying down ecodesign requirements for household dishwashers pursuant to Directive 2009/125/EC of the European Parliament and of the Council amending Commission Regulation (EC) No 1275/2008 and repealing Commission Regulation (EU) No 1016/2010
(Text with EEA relevance)
Article 1
Subject matter and scope
Article 2
Definitions
Article 3
Ecodesign requirements
Article 4
Conformity assessment
Article 5
Verification procedure for market surveillance purposes
Article 6
Circumvention
Article 7
Indicative benchmarks
Article 8
Review
Article 9
Amendment to Regulation (EC) No 1275/2008
Article 10
Repeal
Article 11
Transitional measures
Article 12
Entry into force and application
ANNEX I
Definitions applicable for the annexes
ANNEX II
Ecodesign requirements
1. PROGRAMME REQUIREMENTS
2. ENERGY EFFICIENCY REQUIREMENTS
3. FUNCTIONAL REQUIREMENTS
4. LOW POWER MODES
5. RESOURCE EFFICIENCY REQUIREMENTS
6. INFORMATION REQUIREMENTS
ANNEX III
Measurement methods and calculations
1. ENERGY EFFICIENCY INDEX
2. CLEANING PERFORMANCE INDEX
3. DRYING PERFORMANCE INDEX
4. LOW POWER MODES
ANNEX IV
Verification procedure for market surveillance purposes
Parameter |
Verification tolerances |
Eco programme energy consumption (EPEC) |
The determined value (*1) shall not exceed the declared value of EPEC by more than 5 %. |
Eco programme water consumption (EPWC) |
The determined value (*1) shall not exceed the declared value of EPWC by more than 5 %. |
Cleaning performance index (IC) |
The determined value (*1) shall not be less than the declared value of IC by more than 14 %. |
Drying performance index (ID) |
The determined value (*1) shall not be less than the declared value of ID by more than 12 %. |
Programme duration (Tt) |
The determined value (*1) shall not exceed the declared value by more than 5 % or 10 minutes, whichever is the longer. |
Power consumption in off mode (Po) |
The determined value (*1) of power consumption Po shall not exceed the declared value by more than 0,10 W. |
Power consumption in standby mode (Psm) |
The determined value (*1) of power consumption Psm shall not exceed the declared value by more than 10 % if the declared value is higher than 1,00 W, or by more than 0,10 W if the declared value is lower than or equal to 1,00 W. |
Power consumption in delay start (Pds) |
The determined value (*1) of power consumption Pds shall not exceed the declared value by more than 10 % if the declared value is higher than 1,00 W, or by more than 0,10 W if the declared value is lower than or equal to 1,00 W. |